I've just purchased this bike as a non runner due to the alarm ( datatool system 3) I bypassed the alarm and it run like a dream. I then proceeded to remove the ararm by following all the wires and removing the alarm, re soldering the original wires and heat sealing them.
However I'm left with 4 Black wires with green bands spare, one in a small block with some other wires no live feed. Another from the fuse box again no live feed, One spliced into an orange cable with white stripe No Live feed And the other spliced into 3 red cables with white strip and grey bands This is 12V live.
Everything lights up as it should on the dash but the fuel pump doesn't prime or start.
any suggestions would be greatly welcomed. Thanks.
