Home Improvement Stack Exchange
Home Improvement Stack Exchange

Questions tagged [laundry]

125 questions
14
votes
5 answers

Pulley setup to raise a laundry drying bar levelly

I bought a bike hoist which I modified to use to raise and lower a bar that acts as a drying rack for damp clothes in my laundry room. I now have the following setup: The problem is that when I pull on the rope attached to the wall, the right side…
derNincompoop
  • 398
  • 5
  • 8
  • 17
10
votes
3 answers

I just bought a house and I see a gas line, 110v and 220v outlet in the laundry room. Does this mean I can install either a gas or electric dryer?

Laundry room with gas and/or dryer. (brighten up outlet pic - Harper)
dkm
  • 103
  • 1
  • 1
  • 5
9
votes
2 answers

Is it better to run one large load or multiple small loads to extend life of bearing?

I recently replaced the bearing in my whirlpool cabrio top loading washer. I got to thinking and had no idea which would be safer for the bearing. On one end it's a greater load on the washer, but on the other end you are rotating the bearing more…
Tyler Raber
  • 93
  • 1
  • 3
5
votes
2 answers

Should we reinforce our laundry floor to prevent our washer from walking?

We have an LG front loading washer that vibrates violently and walks when it goes into the spin cycle. Our house is wood framed, built in 1991, and our laundry room floor is vinyl. We've had multiple service calls and while the inner drum was…
Tim Brennan
  • 53
  • 1
  • 1
  • 5
5
votes
1 answer

Why is my laundry standpipe overflowing from kitchen sink activity?

My kitchen is next to my laundry room. Whenever my kitchen faucet (double bowl style) doesn’t drain water, I run the disposal and I see water filling on the second bowl (the one without the disposal). As water goes down in both bowls, water and food…
Yvonne V
  • 51
  • 1
5
votes
2 answers

How to remove plywood countertop in laundry room that’s glued?

What is the best way to remove a plywood countertop in the laundry room that’s glued in place? Is it possible to leave the support pieces that are screwed into the wall for my replacement countertop (butcher block)?
Katie
  • 109
  • 6
5
votes
2 answers

Can I split a single washing machine outlet for a lamp?

I have a single three prong socket in my wall for my washing machine. I would like to put a small lamp on the counter next to the washer but there are no other sockets anywhere in my laundry room. If I use a heavy duty splitter can I plug my washer…
Normand Hébert
  • 59
  • 1
  • 2
5
votes
0 answers

Dryer plug different from wall connection

I have a new out building with a laundry room. The wall plug in the new laundry room is not the same as the plug on the dryer. Do I need a new dryer or can I get a new cable for the dryer? Here is the dryer connection: And here is the wall plug.
GBG
  • 291
  • 1
  • 2
  • 11
5
votes
1 answer

Advice for swapping out my gas dryer myself

My (rather old) washer blew up on me a few weeks ago (Apparently it's been unbalanced for a while. Came with the place and I never thought too much of the vibration until it was too late.) and am getting a brand new set delivered on my new set…
user64049
4
votes
3 answers

Are four brackets adequate for an 8-foot wire laundry shelf?

I am purchasing wire shelving for an 8 foot wide concrete wall laundry. I will hang two 8 foot by 16 inches. Are 4 vertical wall brackets enough to support it? I understand I should space them every 24 inches. Is this correct? Do I really need the…
Rick
  • 889
  • 8
  • 22
  • 40
4
votes
6 answers

Do I need a vent fan in an interior laundry room?

I am renovating a few rooms including an existing laundry room. It currently has one exterior window and another openable window onto an existing mudroom (which also has exterior windows). After the renovation, the laundry will lose the exterior…
bib
  • 33,975
  • 10
  • 68
  • 102
4
votes
2 answers

Washer drain pipe overflow

We recently just moved. A week in. It's been raining on and off for the past few days. This morning I noticed a huge puddle in my laundry/half bath. Couldnt find the source. An hour ago I heard a gushing of water and ran into the bathroom and notice…
Tasha
  • 41
  • 2
3
votes
1 answer

I need help identifying this screw

Our washing machine (Logik L712WM20) door glass broke and I’m trying to replace it. However I don’t know what this screw is. Does anyone know what the screw is and what tool I need to remove it?
user176788
  • 31
  • 1
3
votes
3 answers

Dryer vent issue - not enough vent to hook up hose

As stated in the title - looking at my girlfriend's dryer/vent setup...realized she does not have a hose currently connected. Not great. The hole in the back wall (it's in her garage) barely has any vent protruding to clamp the hose to, and she said…
bobellis75
  • 31
  • 1
  • 4
3
votes
2 answers

Do I need to add Mapei Mapelastic AquaDefence over the plywood or over the hardiebacker?

Do I need to add Mapei Mapelastic AquaDefence over the plywood or over the hardiebacker or none? I’m installing the flooring tiles in the laundry room. I am going to have hardiebacker screwed to plywood and tiles applied on hardiebacker. Do I need…
Dan
  • 31
  • 1
  • 2
1
2 3
…
8 9