Questions tagged [barn]
39 questions
11
votes
4 answers
Can I run 275ft underground cable to pole barn?
I have a new 1500 sqft pole barn that needs electric. I expect to need 100Amp service at the barn which will have a 220V 15A compressor and 220V 25A welder. The rest of the barn will be 110V fluorescent lights, and few if any high amperage tools. My…
phoyt
- 121
- 1
- 6
8
votes
5 answers
Does an electric heater lose efficiency if the elements are rusty/corroded?
I have a pole barn with an electric garage heater to keep it above freezing (I have it set to 40° F and the barn is insulated). Recently I had a major water leak (it didn't freeze, a connector was bad) and the barn was very damp for a couple…
Tobias J
- 227
- 2
- 6
7
votes
3 answers
What size breaker box/amps do you think I'll need for my new pole barn gymnasium?
I have 200 amp service at my house and running electric 200 ft to a 50 by 80 pole barn with 60 by 50 basketball court. So my electric needs will be
Several warehouse high bay lights
wood furnace blower
pump for water cistern
Lights in finished…
fox87
- 71
- 1
- 4
7
votes
3 answers
How to frame for a drywall ceiling with 8 feet between trusses?
I have a post frame building that was recently constructed where the post and joists have 8 foot on center spacing. The building is 38' x 54' and we had a 2nd floor built on the North end of it which measures 38' x 30. This 2nd floor is to be a…
ModulusTwo
- 73
- 1
- 6
6
votes
3 answers
How can I seal this hanging electrical outlet in my horse barn?
I really am not a fixer type of gal but this seems like it should be simple enough. Please respond appropriately for someone who has limited knowledge.
I have a hanging outlet in my horse barn. It seems to be properly wired per a contractor…
user14488
- 61
- 1
6
votes
2 answers
Sacrificial Barn Roof
So I am building a rather large (large for me anyway) barn/sheep shelter. It will measure 16x48 when complete. I have already started the framing, as you can see in the pics (the diagonal pieces are just temporary braces). When complete this will be…
Kerry Thomas
- 749
- 1
- 11
- 23
5
votes
1 answer
Will the concrete slab in a partially heated shed conduct a lot of heat to the unconditioned area?
I have a barn-garage type outbuilding (I believe it was a small barn originally; it has that kind of tall, roomy upper loft). It's about 40 by 20 feet. It's got a concrete foundation and the lower part is divided into two equal sized rooms.
I'm…
Nathan Knutson
- 195
- 1
- 7
4
votes
3 answers
How should I insulate a room built into a metal barn?
I'm building a room into our (existing) barn; how should I best go about insulating it?
The barn is a Morton building -- pole barn construction, metal siding. It's closed on three sides but open on the fourth, so it's not as much a closed-in…
jacobian
- 143
- 1
- 4
4
votes
2 answers
Wiring a pole barn that is 750' from my main power box
I have a barn that is 750' from my main panel. I would like to run power down to it myself because the power company quoted some crazy high prices. I plan on burying the wire and would like to know what size wire I should go with or if it is too far…
Tony
- 41
- 1
- 2
3
votes
5 answers
How to make pressure treated wood look old quickly
We are adding a porch onto our old tobacco barn and are using pressure treated lumber.
We started in July to prepare for my daughter's outdoor wedding in late October. I would like for the porch wood to look old like the barn.
I have seen a lot…
Cindy
- 31
- 1
- 1
- 2
2
votes
3 answers
Cleaning up very old oak and other hardwood roof beams
I am building a stone barn and have just acquired an assortment of very old oak and other hardwood beams (with nails, dirt, the lot) to be used to construct the barn roof. A lot of this wood is filthy with lots of rot and dead wood. I need an…
Eric Crane
- 21
- 1
2
votes
3 answers
Mounting a sliding barn door without a header
I have a hallway that leads into a group of bedrooms. I would like to install a sliding barn door to close these rooms off. There is not currently a header of any kind above this opening. I'm fine with leaving it open for air flow. But I need to…
user2429794
- 145
- 1
- 1
- 7
1
vote
4 answers
How do I get a lawnmower in and out of an old barn?
I have a barn/large coup built in the 1890s in my back yard. It's foundation is just a 3 foot deep concrete pour around the perimeter. Later they filled half of it with concrete on half the floor.
The problem I am having is that poured floor is…
DMoore
- 50,637
- 16
- 93
- 208
1
vote
5 answers
Sill plate alternatives when *not* using pressure treated wood?
I have a barn I am restoring. I do not want to use pressure treated wood for the sole plate or sill plate. My carpenter would use 4 x6 locust at 12 foot lengths, but we cannot find any.
Can anyone suggest an alternative? And if so, what kind of…
Marianna Mayer
- 11
- 1
- 2
1
vote
1 answer
What can I build/use for a door in an old barn?
I have a very small barn/chicken coop on my land that we basically use as a shed. It currently has a standard door on it. However I just got a new riding lawnmower and would like to store it in said barn. It needs a ramp (there is a lip) and it…
DMoore
- 50,637
- 16
- 93
- 208